TheaterChase(strip. Some example procedures showing how to display to the pixels:ĬolorWipe(strip.Color(255, 0, 0), 50) // RedĬolorWipe(strip.Color(0, 255, 0), 50) // GreenĬolorWipe(strip.Color(0, 0, 255), 50) // Blue Strip.show() // Initialize all pixels to 'off' Lowering the pixel count back down again returns the strand to normal expected behavior. The effects are perfect until increasing the pixel count, at which point the strand once again freezes. Lowered to 25 and then 5 brightness in the code with the same results as before. If (F_CPU = 16000000) clock_prescale_set(clock_div_1) Using 4x AA standard rechargeable batteries for each meter of LEDs. Anyone can shed some light on what may be causing this? #include Īdafruit_NeoPixel strip = Adafruit_NeoPixel(111, PIN, NEO_GRB + NEO_KHZ800) ![]() ![]() But on three separate strands I still get the same results. Since the 112th LED falls on the second segment of LEDs, I tried swapping out that entire segment. ![]() However, if I increase the number of LEDs in the code to 112 or more, the strip completely locks up after a successful upload to the Trinket. ![]() The neopixel strandtest and other examples (including FastLED examples) run successfully if the code is set for 111 LEDs. I've encountered a problem in this simple setup of an Adafruit Trinket (5v) controlling two segmented 60LED/m WS2812B LED strips.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |